SMA MC-Box 6.3 - Manual (Page 37)

SMA Solar Technology AG 10 Decommissioning
Operating Manual MC-BOX-6_12-BE-en-20 37
10 Decommissioning
10.1 Disassembling the Multicluster Box 6.3
Procedure:
1. Open the Multicluster Box with the switch cabinet key.
2. Remove all cables from the Multicluster Box.
3. Loosen the fastening screws of the Multicluster Box.
4. Take the Multicluster Box down.
5. Lock the Multicluster Box with the switch cabinet key.
10.2 Disassembling the Multicluster Box 12.3
1. Open the Multicluster Box with the switch cabinet key.
2. Remove all fastening screws from the kick plates at the front and rear.
3. Set the screws aside. They will be needed later to reattach the kick plates.
4. Remove all cables from the Multicluster Box.
5. Loosen and remove the fastening screws of the Multicluster Box.
6. Close the enclosure of the Multicluster Box with the switch cabinet key.
8. Remount the kick plates on the Multicluster Box.
10.3 Storing the Product
Store the Multicluster Box in a dry place where the ambient temperature is between − 25°C and
+50°C at all times.
10.4 Disposal
Dispose of the Multicluster Box at the end of its service life in accordance with the disposal regulations
for electronic waste applicable at the installation site at that time.
8"3/*/(
Danger of crushing limbs and damage to the Multicluster Box
The Multicluster Box can fall down as a result of improper transport and cause severe crushing
injuries.
• Take the weight of the Multicluster Box of approximately 60 kg into account.
7.
8"3/*/(
Danger of crushing limbs and damage to the Multicluster Box
• Transport the Multicluster Box with a forklift truck, pallet truck, or crane (see Section 5.2.2
"Transporting the Multicluster Box 12.3", page 17).