SMA BATFUSE-B.01 - Manual (Page 7)

SMA Solar Technology AG 2 Safety
Operating Manual BatFuse-BE-en-30 7
Any use of the product other than described in the Intended Use section does not qualify as
appropriate.
The enclosed documentation is an integral part of this product. Keep the documentation in a
convenient place for future reference and observe all instructions contained therein.
The type label must remain permanently attached to the product.
2.2 Skills of Qualified Persons
Qualified persons must have the following skills:
• Training in off-grid systems from SMA Solar Technology AG
• Training in how to deal with the dangers and risks associated with installing and operating
electrical devices and batteries
• Training in the installation and commissioning of electrical devices
• Knowledge of and adherence to the local standards and directives
• Knowledge of and compliance with this document and all safety precautions
2.3 Safety Precautions
This section contains safety precautions that must be observed at all times when working on or with
the product.
To prevent personal injury and property damage and to ensure long-term operation of the product,
read this section carefully and follow all safety precautions at all times.
Risk of injury due to short-circuit currents
Short-circuit currents in the battery can cause heat build-up and electric arcs. Burns or eye injuries
due to flashes may result.
• Follow all safety and maintenance instructions provided by the battery manufacturer.
• Remove watches, rings and other metal objects.
• Use insulated tools.
• Do not place tools or metal parts on the battery.
• When working on the installation, make sure that all DC cables have been removed from the
pole connections of the battery and that the BatFuse is voltage-free.
• Make sure that the polarity of the cables to the battery is correct.
• Make sure that the mechanical connection at the terminals is tight.
• Open the load-break switch quickly and then close it.
• Ensure that the enclosure lid of the BatFuse is closed when the load-break switch is closed.