SMA BATFUSE-B.01 - Manual (Page 12)

5 Transport and Mounting SMA Solar Technology AG
12 BatFuse-BE-en-30 Operating Manual
Additionally required mounting material (not included in the scope of delivery):
☐ At least four screws that are suitable for the support surface
☐ At least four washers that are suitable for the screws
☐ If necessary, at least four screw anchors suitable for the support surface and the screws
Procedure:
1. Ensure that no cables are laid in the wall which could be damaged when drilling holes.
2. Attach the anchorage brackets either vertically,
horizontally or diagonally on the rear panel of the
BatFuse.
3. Mark the position of the drill holes at the mounting location.
4. Drill the holes.
5. Insert screw anchors into the drill holes if necessary.
6. Fasten the BatFuse with at least four suitable screws and the anchorage brackets.
7. Ensure that the BatFuse is firmly attached.
Danger to life due to fire or explosion
Despite careful construction, electrical devices can cause fire.
• Do not mount the BatFuse on flammable construction materials.
• Do not mount the BatFuse near highly flammable materials.
• Do not mount the BatFuse in potentially explosive areas.