SMA SC 500CP-US Maintenance Manual - Manual (Page 4)

Warnings on this product SMA America, LLC
4 SCCP-US-WH-US_en-30 Maintenance Manual
Warnings on this product
The following symbols are used as product markings with the following meanings.
General Warnings
Symbol Description
Warning regarding dangerous voltage
The product works with high voltages. All work on the product must only be performed as described in
the documentation of the product.
Beware of hot surface
The product can become hot during operation. Do not touch the product during operation.
Electric arc hazards
The product has large electrical potential differences between its conductors. Arc flashes can occur
through air when high-voltage current flows. Do not work on the product during operation.
Risk of fire
Improper installation of the product may cause a fire.
Observe the operating instructions
Read the documentation of the product before working on it. Follow all safety precautions and
instructions as described in the documentation.
:$51,1*
All electrical installations must be made in accordance with the local and National Electrical Code
®
ANSI/NFPA 70
or the Canadian Electrical Code
®
CSA C22.1. This document does not and is not intended to replace any local, state,
provincial, federal or national laws, regulations or codes applicable to the installation and use of the product, including
without limitation applicable electrical safety codes. All installations must conform with the laws, regulations, codes and
standards applicable in the jurisdiction of installation. SMA assumes no responsibility for the compliance or
noncompliance with such laws or codes in connection with the installation of the product.
Before installing or using the product, read all of the instructions, cautions, and warnings in this manual.
Before connecting the product to the electrical utility grid, contact the local utility company. This connection must be
made only by qualified personnel.
Wiring of the product must be made by qualified personnel only.