SMA CBL-DC-CMB1-10 - Manual (Page 9)

Transport
106183_en_00 PHOENIX CONTACT 9
2 Description
The CBL-DC-CMB1-10 switching device combination is a string combiner box for up to 12
or 14 photovoltaic strings. The solar string cables are guided through cable glands and into
the housing. The positive pole of the solar strings is connected to the UK 10,3-HESI 1000V
fuse modular terminal blocks and the negative pole of the solar strings is connected to the
STU 35/4x10 BU feed-through terminal blocks or as well to UK 10,3-HESI 1000V fuse mod-
ular terminal blocks. The output cables are connected to the UKH 150 and UKH 150 BU
high-current terminal blocks or to the load break switch.
Properties
– Degree of protection: IP65
– Housing: polycarbonate
– Connection of up to 12 or 14 solar strings
– UK 10.3 HESI 1000V fuse modular terminal blocks
3 Transport
The CBL-DC-CMB1-10 is delivered in cardboard packaging. Where necessary, the pack-
aging features information on how to handle the packaged products as well as shock, tilt,
moisture, and temperature indicators. In order to avoid damage, this information must be
observed during both transport and storage.
The CBL-DC-CMB1-10 may only be transported to its destination in its original packaging.
Please observe the notes on the packaging. Secure the CBL-DC-CMB1-10 during trans-
port, taking into account the center of gravity of the device. The same applies when relocat-
ing, moving or returning the equipment.
Internal transport is only permitted if the transport goods are adequately secured against
slipping and falling. Only use suitable floor conveyor vehicles.
3.1 Transportation method
The device must be kept horizontal during transport. The maximum permissible deviation
from the horizontal position is 15°. Only suitable and approved hoisting gear may be used
to unload and transport the equipment.
Do not climb onto the devices or packaging. However, if it should prove necessary, protect
the surfaces and frame to prevent damage. When transporting the equipment or storing it
temporarily, make sure that the surfaces are protected from the elements and any external
influences, and that they are kept dry and clean.
– Please observe the humidity specifications and the temperature range specified for
transport.
– Observe the warnings on the transport packaging.
– Observe the rupture load classes. This means that the least sensitive parts must be
placed at the bottom.
– Stretch and strap bulky goods.