SMA CBL-DC-CMB1-10 - Manual (Page 24)

CBL-DC-CMB1-10
24 PHOENIX CONTACT 106183_en_00
7.3 Cleaning
Cleaning the housing
Clean the outside surfaces of the housing with a damp cloth. Do not use any corrosive
cleaning agents, thinners, abrasive cleaners or hard objects that could damage the surface.
8 Removal/disposal
To decommission a system, proceed according to the procedures specified by the machine
or system manufacturer. When decommissioning the switching device combination or parts
thereof, ensure that the components used:
– Are correctly reused in another system.
Or
– Are disposed of according to the applicable environmental regulations, and in this case
can never be reused.
Safety shoes must always be worn during mounting and removal. During removal, the
switching device combination must be held by a second person to prevent it from falling.
During decommissioning/removal, make sure that there is sufficient space available.
Removal procedure:
– The voltage must be disconnected by the user/a skilled electrical engineer.
– Open the CBL-DC-CMB1-10.
– Loosen the wires.
– Release the cable entries and pull out the cables.
– Close the CBL-DC-CMB1-10.
– Secure the CBL-DC-CMB1-10 to prevent it from falling.
– Release the mounting screws on the CBL-DC-CMB1-10.
– Remove the CBL-DC-CMB1-10.
9 Storage and storage conditions
The storage location should be dry and protected against harmful environmental influences
such as UV light.
– Temperature range: -40°C ... 60°C
– Air pressure: 2000 m above sea level, maximum
– Permissible humidity (storage/transport): 5% ... 95%