Eagle Electronics SeaFinder 250 DF User Manual

Page 33

Screw the suction cup onto the bracket using the supplied screw and

flat washer. Tie the nylon cord through the hole in the top of the

bracket. When using this transducer, tie the other end of the nylon cord

to the boat. This will help prevent the loss of the transducer if it comes

off the boat.

Portable transducer assembly: rear view (left) and side view (right.)

Clean the chosen area of the hull before attaching the suction cup. Lo-

cate the transducer on the hull as shown in the following figure. Don't

allow the bracket to extend below the hull, because water pressure

against it can cause the suction cup to come off at speed.

Washer

Nut

Bolt

Screw

Suction

cup

Transducer

Tie nylon

cord

here