Eagle Electronics SeaFinder 250 DF User Manual

Page 15

Third, a transducer CAN NOT shoot through wood and metal hulls.

Those hulls require either a transom mount or a thru-hull installation.
Fourth, if your Skimmer transducer has a built in temp sensor, it will

only show the temperature of the bilge, not the water surface temp.

Follow the testing procedures listed in the shoot-thru-hull installation

section at the end of this instruction booklet to determine if you can

satisfactorily shoot through the hull.
Transom Transducer Assembly and Mounting
The best way to install the transducer is to loosely assemble all of the

parts first, place the transducer's bracket against the transom and see if

you can move the transducer so that it's parallel with the ground.
1. Assembling the bracket. Press the two small plastic ratchets into the

sides of the metal bracket as shown in the following illustration. Notice

there are letters molded into each ratchet. Place each ratchet into the

bracket with the letter "A" aligned with the dot stamped into the metal

bracket. This position sets the transducer's coarse angle adjustment for a
14

° transom. Most outboard and stern-drive transoms have a 14° angle.

Align plastic ratchets in bracket.

2. Aligning the transducer on the transom. Slide the transducer

between the two ratchets. Temporarily slide the bolt though the

transducer assembly and hold it against the transom. Looking at the

transducer from the side, check to see if it will adjust so that its face

is parallel to the ground. If it does, then the "A" position is correct for

your hull.

Dot