Eagle Electronics SeaFinder 250 DF - Manual (Page 17)

13
Assemble transducer and bracket.
4. Drilling mounting holes. Hold the transducer and bracket assembly
against the transom. The transducer should be roughly parallel to the
ground. The transducer's centerline should be in line with the bottom
of the hull. Don't let the bracket extend below the hull!
Mark the center of each slot for the mounting screw pilot holes. You
will drill one hole in the center of each slot.
Drill the holes using the #29 bit (for the #10 screws).
Position transducer mount on transom and mark mounting holes.
Side view (left) and shown from above (right).
5. Attaching transducer to transom. Remove the transducer from
the bracket and re-assemble it with the cable passing through the
bracket over the bolt as shown in the following figures.
Nut
Metal
washer
Metal washer
Bolt
Rubber
washers
Transom
Transom