Eagle Electronics SeaFinder 250 DF User Manual

Page 25

Shoot-thru-hull Installation
1. Make sure the area is clean, dry and free of oil or grease, then sand

both the inside surface of the hull and the face of the transducer with

100 grit sandpaper.
The sanded hull area should be about 1-1/2 times the diameter of the

transducer. The surface of the hull must be flat so the entire trans-

ducer face is in contact with the hull prior to bonding. After sanding,

clean the hull and transducer with rubbing alcohol to remove any

sanding debris.

Epoxy transducer to hull.

WARNING:

Use only the epoxy available from LEI. It has been for-
mulated to work with these installation procedures.
Other epoxy types may be too thin or may not cure to
the right consistency for optimum transducer perform-
ance.

2. The epoxy consists of the epoxy itself and a hardener. Remove the

two compounds from the package and place them on the paper plate.

Spread epoxy here

Sand this surface

Orient the Skimmer
with the nose facing
the bow of the boat.

To bow