ShoreLand'r SLKB150TA - Manual (Page 9)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003957
Page 9 04/10/2008
See Diagram E
Rocker Bushings:
Identify the front and rear of the rocker bogie as shown in the 1st &
2nd axle drawing below. Raise the rocker bogie up into the center
channel of the spring bracket. Secure with a 3/4” X 5-1/2” hex bolt
through the rocker and the middle shackle on the spring bracket.
Tighten using a 3/4” hex lock nut. Repeat this procedure on the
other rocker on the opposite side of the trailer and also for the 2nd
& 3rd axles as shown below.
First Axle Installation:
Align the eye of the spring on the first axle with the hole provided in
the spring bracket. From the outside in, insert a 9/16” x 3 ¾” hex
bolt through the spring bracket and the eye of the spring. Secure
with a 9/16” hex lock nut.
Raise the rear hook end of the spring and axle assembly up so it
is up inside the rocker bogie. Secure in place by placing a 9/16” x
3 ¾” hex bolt through the hole in the rocker bogie just below the
spring leaf. Secure with a 9/16” lock nut.
Second Axle Installation
Align the eye of the spring on the second axle with the hole pro-
vided in the rear of the rocker bogie. From the outside in, insert a
9/16” x 3 ¾” hex bolt through the rocker bogie and the eye of the
spring. Secure with a 9/16” hex lock nut.
Raise the rear hook end of the spring and axle assembly up so it
is up inside the rocker bogie. Secure in place by placing a 9/16” x
3 ¾” hex bolt through the hole in the rocker bogie just below the
spring leaf. Secure with a 9/16” lock nut.
Rear Axle Installation:
Align the eye of the spring on the third axle with the hole provided
in the rear of the rocker bogie holding the rear of the second axle.
From the outside in, insert a 9/16” x 3 ¾” hex bolt through the rocker
bogie and the eye of the spring. Secure with a 9/16” hex lock nut.
Raise the rear hook end of the springs on the third axle up into the
spring bracket. Place a spring bushing above the hook leaf of the
spring located inside the spring bracket channel. Secure the spring
in the spring bracket by placing a spring support channel under the
spring. Insert a 9/16” x 4-3/4” hex bolt from the outside-in through
the spring support channel, spring bracket and then through the
1st & 2nd Axle 2nd & 3rd Axle