ShoreLand'r SLR95TAL - Manual (Page 8)

Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004307
Page 8 of 16 2/24/2011
Triple axles for the 150TAL:
Locate the two brass tees. Thread the male port of
the tees into the female end of the 18” brake hoses
running up from the axles just installed on the front
and second axles. Tighten.
Remove the plastic cap from the end of the frame
brake line coming off of the side frame by the axle.
Carefully pull the brake hose enough so that it will
reach the port of the tee just threaded into the brake
hose on the first axle. Thread the brake hose fitting
into the top port of the tee installed on the front axle and tighten.
-beam.
Connect the 42” hose that is in the kit to the tee on the first
axle and route over and into the top port in the tee by the
second axle. Tighten. This hose can be coiled and a hose
clip placed on it and secured to the I-beam with a self-
tapping screw.
Connect the 60” hose to the other port of the tee above
the second axle route it back thru the brake line clip by
the third axle and then down and thread into the side port
of the brass block. Tighten all connections. This hose can
be held up in place by adding a hose clip and self-
tapping screw and attaching to the I