ShoreLand'r SLR95TAL - Manual (Page 10)

tongue harness to white wire trailer harness, and green wire tongue harness to brown wire on
the trailer harness.
If the tongue harness comes with a red wire in the harness then the connections need to be
made as follows. Connect the single bullet ends of the red wire in tongue harness to green
wire trailer harness, green wire tongue harness to brown wire trailer harness, brown wire
tongue harness to yellow wire trailer harness, and white wire tongue harness to white wire
trailer harness. These wires are extending out the hole in the top of the tongue and are taped
there during shipping.
• Once attached these wires can be placed down inside the tongue.
• Locate the three wire plugs: brown, white, and yellow, and brown, white, and green at the
rear of the tongue. Mate these plugs with those of the side frame wire harnesses and plug
together making sure they have a good connection. Place any excess wiring inside the rear of
the tongue.
• Locate the breakaway switch that is already attached and wired into the main wire harness
just installed in the front of the tongue. Position it so it is approximately 3” behind the coupler.
Mark the mounting hole location. Drill a 13/64” pilot hole in the tongue. Insert the 1/4” self-
drilling screw provided and secure in place.
Battery Box Installation Instructions:
Locate the battery boxes.
Note that there are two
battery boxes and two
batteries. They are both
required to power the
brake system in the
event of a disconnection
from the tow vehicle.
Frame Brake Hose
Electric
over
Hydraulic
Brake
Actuator
SD Control Module
Battery Boxes
1. Attach the two battery
boxes to the front of the
side frames mating the
holes in the battery
boxes with those pre-
drilled in the side frames.
Mount them to the side
frames using 1/4” x 1”
carriage bolts and 1/4”
lock nuts. Once all bolts
are installed, tighten.
Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004307
Page 10 of 16 2/24/2011