ShoreLand'r SLR95TAL - Manual (Page 13)

brakes or they are malfunctioning, see your local ShoreLand’r dealer immediately to rectify
the problems.
Jack:
Remove the hardware bag provided by the jack manufacturer and take out the mounting
plates. From hardware bag, take out four (4) 3/8” X 6” stainless steel hex bolts and four (4) 3/8”
stainless steel lock nuts with nylon inserts, Position the jack on the tongue in a location that
best fits your watercraft. Secure with the stainless steel hardware. The remaining hardware in
the bag that was removed from the jack may be discarded
.
Front Bunk:
Mount the bunk bracket weldment
into the pivot base weldment using a
5/8” X 4-1/2” stainless steel hex head
bolt and secure with a 5/8” stainless
steel hex lock nut with nylon insert.
Mount the bunk assembly onto the
bunk bracket weldment using two (2)
1/2” X 1-1/2” stainless steel hex bolts
and secure with two (2) 1/2” stainless
steel hex lock nuts with nylon insert.
Repeat this procedure on the opposite side of the trailer.
Rear Bunk:
Mount the bunk bracket weldment into
the pivot base weldment using a 5/8” X
4-1/2” stainless steel hex head bolt and
secure with a 5/8” stainless steel hex
lock nut with nylon insert. Mount the
bunk assembly onto the bunk bracket
weldment using two (2) 1/2” X 1-1/2”
stainless steel hex bolts and secure with
a two (2) 1/2” stainless steel hex lock
nuts with nylon inserts. Repeat this
procedure on the opposite side of the
trailer.
Wiring:
Run the wiring from the frame outlet to the bunk bracket weldment and run thru the inside and
exit out the end of the bunk bracket weldment. The flex conduit located in the hardware box
will be used to cover the frame wire harness before it enters the bunk bracket weldment. Install
grommets over 3/8” flex conduit in wire holes on bunk bracket weldment. Using wire ties
secure the flex conduit to the crossmember. Leave the wire until after the mounting of the
taillights on the bunk brackets tube.
Taillights:
Mount the left taillight to the taillight bracket on the bunk bracket weldment. The license plate
bracket will slide between the taillight and the welded-on taillight bracket on the bunk bracket
Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004307
Page 13 of 16 2/24/2011