ShoreLand'r 2x3 - Manual (Page 4)

Safety Chain:
Insert a 3/8” X 1-1/4” hex bolt with a 3/8” flat washer and
safety chain through the lower hole on the front of the
tongue. Secure with a 3/8” flat washer and 3/8” flange lock
nut. Repeat the procedure on the opposite side of the
tongue.
Coupler:
Mount the coupler onto the tongue with one (1) 1/2” X 4”
hex bolt into the rear of the couplerand tongue and using
two (2) 1/2” X 1” hex bolts into the two (2) front holes on
the coupler and tongue. Secure with 1/2” flange lock nuts.
Bunks:
Mount the adjustable bunk brackets with the adjustable
bunk clamps to the front crossmember in a location that
would best fit your watercraft. Secure with 1/2” X 3-9/16” X
3” square u-bolts and 1/2” flange lock nuts.
Mount the adjustable bunk channel weldment to the rear
pivot in a location that best fits your watercraft using a 1/2”
X 4-1/2” hex bolt and 1/2” flange lock nut per adjustable
bunk channel weldment.
Secure the bunk assemblies to the adjustable bunk
brackets on the front crossmember using 3/8” X 1” hex
bolts and 3/8” flange lock nuts.
Secure bunk assemblies to the adjustable bunk channel
weldments on the rear pivot using 3/8” X 1” hex bolts and
3/8” flange lock nuts.
DO NOT OVER TIGHTEN - the bunks must pivot freely
to conform to the boats hull.