ShoreLand'r 2x3 - Manual (Page 10)

Actuator & Safety Chain:
Slide the actuator (Ref.#36) into the actuator housing unit
(Ref.#5) and secure with two pins and snap rings provided
with the actuator. Secure the actuator-housing unit to the
front of the tongue using three-(3) ˚” X 4” hex bolts and
˚” flange lock nuts. Using a ˚” X 5” hex bolt on lower
right mounting hole on tongue, secure the safety chain.
Place a ˚” flat washer on ˚” X 5” hex bolt followed by one
safety chain and insert into actuator housing unit and
tongue. Place the second safety chain on the bolt followed
by a ˚” flat washer and ˚” flange lock nut. Tighten.
Brakes:
Refer to the brake manual for service and maintenance.
Rear Pivot:
The rear pivot is adjustable. Place the rear pivot in one (1)
of the two (2) pre-drilled holes in the rear of the side
frames. Secure with 5/8” X 3-1/2” hex bolts, 5/8” flat
washers, nylon washer and 5/8” hex lock nut.
Roller Assembly:
Refer to Doc# 0002774 for assembly instructions.
Keel Roller:
Refer to Doc# 0002774 for assembly instructions.