ShoreLand'r 2x3 - Manual (Page 14)

Actuator & Safety Chain:
Slide the actuator (Ref.#37) into the actuator housing unit
(Ref.#4) and secure with two pins and snap rings provided
with the actuator. Secure the actuator-housing unit to the
front of the tongue using three-(3) ˚” X 4” hex bolts and ˚”
flange lock nuts. Using a ˚” X 5” hex bolt on lower right
mounting hole on tongue, secure the safety chain. Place a
˚” flat washer on ˚” X 5” hex bolt followed by one safety
chain and insert into actuator housing unit and tongue.
Place the second safety chain on the bolt followed by a ˚”
flat washer and ˚” flange lock nut. Tighten.
Brakes:
Refer to the brake manual for service and maintenance.
Bunks:
Mount the adjustable bunk brackets with the adjustable
bunk clamps to the crossmembers in a location that would
best fit your watercraft. Secure with 1/2” X 3-9/16” X 3”
square u-bolts and 1/2” flange lock nuts.
Secure the bunk assemblies to the adjustable bunk
brackets just installed using 3/8” X 1” hex bolts and 3/8”
flange lock nuts.
DO NOT OVER TIGHTEN - the bunks must pivot freely
to conform to the boats hull.