ShoreLand'r 2x3 - Manual (Page 29)

162202-- 2X3 ADJ ROLLER ARM WMENT ............. 1
2 0210127 CARR 3/8-24 X 3 W/1 THRD GR8 ........... 4
3 0210220 CARR 1/2-13 X 4 1/2 GR5 ........................ 1
4 1310121 WASHER USS ALUMINUM FLAT 3/4 ...... 6
5 1440100 HEX LOCKNUT 3/8-24 GRA .................... 4
6 1440102 FLANGE LOCKNUT SMALL 1/2-13 .......... 1
7 1540350 BULL RING PLAIN .................................... 6
8 S-3184 PLASTIC MOLDED SWIVEL BLOCK ....... 2
9 S-3368 INLINE ROLLERPIN 19 1/2 ...................... 2
10 S-3382 ROLLER WITH MOLDED HUB 5IN ........ 6
11 S-3383 ROLLER BUSHING MOLDED .................. 6
12 S-3384 FLAT WASHER 2OD X 1.150ID ALUM ... 6
13 S-3410 T BAR ROLLERPIN .................................. 1
®
2X3 Roller Sub Assemblies
Keel Roller
6-Roller
REF# PART# DESCRIPTIONQTY
Roller Assembly:
Mount the roller assemblies to the rear pivot in a location that best
fits your watercraft. Secure with 1/2” X 4-1/2” carriage bolts
(Ref.#3) and 1/2” flange lock nuts (Ref.#6). Tighten.
Roller Adjustment:
Place your boat on the trailer. Determine the spacing on the roller
rack. It may be neccessary to adjust your roller rack either further
in or out from the position you have it assembled. The boat must
be adjusted to miss any keel or strake which might be on your
particular boat.
IMPORTANT: The roller racks should be spaced as far apart as
possible for stability. This in most cases will also allow your boat to
be as low as possible on the trailer for better trailering, loading and
unloading.
Once the roller racks have been spaced properly for your boat,
position the boat on the trailer with the transom flush with the rear
of the rear roller rack.
Keel Roller Assembly:
Mount the front keel roller assembly to the front crossmember in
the desired vertical position and secure with 3/8” X 3” carriage bolts
(Ref.#4) and 3/8” flange lock nuts (Ref.#6). Tighten.
IMPORTANT: Install keel roller so that the keel support roller
(Ref.#8) will automatically tilt aft (toward the stern or rear of your
watercraft).
Keel Roller Adjustment:
Adjust the front keel roller assembly to the desired position to level
the boat.
Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 www.shorelandr.com 0002774