beautypg.com

ShoreLand'r 2x3 User Manual

Page 22

background image

Actuator & Safety Chain:

Slide the actuator (Ref.#36) into the actuator housing unit
(Ref.#4) and secure with two pins and snap rings provided
with the actuator. Secure the actuator-housing unit to the
front of the tongue using three-(3) ˚” X 4” hex bolts and
˚” flange lock nuts. Using a ˚” X 5” hex bolt on lower
right mounting hole on tongue, secure the safety chain.
Place a ˚” flat washer on ˚” X 5” hex bolt followed by one
safety chain and insert into actuator housing unit and
tongue. Place the second safety chain on the bolt followed
by a ˚” flat washer and ˚” flange lock nut. Tighten.

Brakes:

Refer to the brake manual for service and maintenance.

Bunks:

Mount the adjustable bunk brackets with the adjustable
bunk clamps to the crossmembers in a location that would
best fit your watercraft. Secure with 1/2” X 3-9/16” X 3”
square u-bolts, 1/2” lock washers and 1/2” hex finish nuts.

Secure the bunk assemblies to the adjustable bunk
brackets just installed using 3/8” X 1” hex bolts and 3/8”
flange lock nuts.

DO NOT OVER TIGHTEN - the bunks must pivot freely
to conform to the boats hull.