HEIDENHAIN TNC 320 (340 55x-05) Cycle programming - Manual (Page 328)

328 Touch Probe Cycles: Automatic Datum Setting
15.5 D
A
TUM FR
OM OUTSIDE OF RECT
A
NGLE (Cy
c
le 41
1, DIN/ISO: G41
1
)
U Traversing to clearance height Q301: Definition of
how the touch probe is to move between the
measuring points:
0: Move at measuring height between measuring
points
1: Move at clearance height between measuring
points
U Datum number in table Q305: Enter the number in
the datum/preset table in which the TNC is to save
the coordinates of the stud center. If you enter
Q305=0, the TNC automatically sets the display so
that the new datum is on the stud center. Input range
0 to 2999
U New datum for reference axis Q331 (absolute):
Coordinate in the reference axis at which the TNC
should set the stud center. Default setting = 0. Input
range -99999.9999 to 99999.9999
U New datum for minor axis Q332 (absolute):
Coordinate in the minor axis at which the TNC should
set the stud center. Default setting = 0. Input range
-99999.9999 to 99999.9999
U Measured-value transfer (0, 1) Q303: Specify
whether the determined datum is to be saved in the
datum table or in the preset table:
–1: Do not use. Is entered by the TNC when old
programs are read in (see “Saving the calculated
datum” on page 314).
0: Write determined datum in the active datum table.
The reference system is the active workpiece
coordinate system.
1: Write determined datum in the preset table. The
reference system is the machine coordinate system
(REF system).