HEIDENHAIN TNC 320 (340 55x-05) Cycle programming - Manual (Page 11)

HEIDENHAIN TNC 320 11
Chang
e
d F
u
nctions of Sof
tw
a
re
340
55x
-05
Changed Functions of Software
340 55x-05
„ The status display for Q parameters was revised (see User’s Manual
for Conversational Programming).
„ The tool table was expanded by the LAST_USE column (see User’s
Manual for Conversational Programming).
„ The graphic simulation was extended and adapted to the iTNC 530
(see User’s Manual for Conversational Programming).
„ Touch probe cycles can now also be used in the tilted working plane
(see User’s Manual for Conversational Programming).