HEIDENHAIN SW 54843x-02 - Manual (Page 598)

598 Tables and overviews
9.4 Compatibility in DIN pr
ogr
a
ms
Feed rate and spindle speed Gx26 Speed limitation þ
G48 Acceleration (slope) 
G64 Interrupted feed þ
G192 Feed per minute for rotary axis –
Gx93 Feed per tooth þ
G94 Feed per minute þ
Gx95 Feed per revolution þ
Gx96 Constant surface speed þ
Gx97 Speed þ
Tool-tip radius compensation G40 Switch off TRC/MCRC þ
G41 TRC/MCRC, left þ
G42 TRC/MCRC, right þ
Zero point shifts G51 Relative zero point shift þ
G53 Parameter-dependent zero point shift 
G54 Parameter-dependent zero point shift 
G55 Parameter-dependent zero point shift 
G56 Additive zero point shift þ
G59 Absolute zero point shift þ
G121 Contour mirroring/shifting þ
G152 Zero point shift, C axis þ
G920 Deactivate zero point shift þ
G921 Deactivate zero point shift, tool dimensions þ
G980 Activate zero point shift þ
G981 Activate zero point shift, tool dimensions þ
Oversizes G50 Switch off oversize þ
G52 Switch off oversize þ
G57 Axis-parallel oversize þ
G58 Contour-parallel oversize þ
G commands for machining