HEIDENHAIN SW 54843x-02 - Manual (Page 59)

HEIDENHAIN MANUALplus 620 59
2.5 T
y
pes of pr
ogr
a
ms
2.5 Types of programs
The MANUALplus supports the following programs/contours:
 Teach-in programs (cycle programs) are used in the "Teach in"
mode of operation.
 smart.Turn and DIN main programs are written in the smart.Turn
mode of operation.
 DIN subprograms are written in the smart.Turn operating mode
and are used in cycle programs and smart.Turn main programs.
 ICP contours are generated during Teach-in in the Teach-in or
Manual mode of operation. The extension depends on the contour
described.
In smart.Turn the contours are saved directly in the main program.
Program type Folders Extension
Teach-in programs
(cycle programs) "nc_prog\gtz" "*.gmz"
smart.Turn and DIN
main programs "nc_prog\ncps" "*.nc"
DIN subprograms "nc_prog\ncps" "*.ncs"
ICP contours "nc_prog\gti"
Turning contours "*.gmi"
Contours of
workpiece blanks "*.gmr"
Contours on face "*.gms"
Lateral surface
contours "*.gmm"