HEIDENHAIN SW 54843x-02 - Manual (Page 17)

HEIDENHAIN MANUALplus 620 17
3.1 Machine mode of operation ..... 72
3.2 Switch-on / Switch-off ..... 73
Switch-on ..... 73
Monitoring EnDat encoders ..... 73
Traversing the reference marks ..... 74
Switch-off ..... 75
3.3 Machine data ..... 76
Input of machine data ..... 76
Machine data display ..... 78
Cycle statuses ..... 81
Axis feed rate ..... 82
Spindle ..... 82
3.4 Setting up a tool list ..... 83
Machine with turret ..... 83
Machine with multifix ..... 83
Tools in different quadrants ..... 84
Filling the turret list from the database ..... 85
Filling the turret list ..... 86
Tool call ..... 87
Driven tools ..... 87
Tool life monitoring ..... 88
3.5 Machine setup ..... 89
Defining the workpiece zero point ..... 90
Homing the axes ..... 91
Setting the protection zone ..... 92
Defining the tool change position ..... 93
Setting C-axis values ..... 94
Setting up machine dimensions ..... 95
Calibrating the tool touch probe ..... 96
Displaying operating times ..... 97
Setting the system time ..... 98
3.6 Tool measurement ..... 99
Touch off ..... 100
Touch probe (tool touch probe) ..... 101
Optical gauge ..... 102
Tool compensation ..... 103
3.7 "Manual Operation" operating mode ..... 104
Tool change ..... 104
Spindle ..... 104
Handwheel operation ..... 104
Manual direction keys ..... 105
Teach-in cycles in Manual mode ..... 105
3 Machine mode of operation ..... 71