HEIDENHAIN SW 54843x-02 - Manual (Page 416)

416 ICP programming
5.12 F
a
ce cont
ours in smar
t.T
u
rn
Polygon on face
You can find the reference dimension ZR with the "select reference
plane" function (see page 411).
ICP generates:
 The FRONT section code with the reference dimension parameter.
In nested contours, ICP generates only one section code.
 A G308 with the parameters contour name and milling depth.
 A G307 with the parameters of the figure.
 A G309.
Reference data of face
ID
Contour name
PT Milling depth
ZR Reference dimension
Parameters of figure
XKM, YKM Center of figure (Cartesian coordinates)
A
Position angle (reference: XK axis)
Q Number of corners
K Length of edge
Ki Width across flats (inscribed circle diameter)
BR Rounding arc