HEIDENHAIN SW 54843x-02 - Manual (Page 410)

410 ICP programming
5.1
1
C and Y axis mac
h
ining in smar
t.T
u
rn
5.11 C and Y axis machining in
smart.Turn
In smart.Turn, ICP supports the definition of milling contours and holes
as well as the creation of milling and drilling patterns that are machined
with the aid of the C or Y axis.
Before you use ICP to describe a milling contour or a hole, select the
plane:
 C axis
 Face (XC plane)
 Lateral surface (ZC plane)
 Y axis
 Y face (XY plane)
 Y lateral surface (YZ plane)
A hole can contain the following elements:
 Centering
 Core hole
 Countersink
 Thread
The parameters are evaluated for drilling or tapping.
You can arrange holes in linear or circular patterns.
Milling contours: The MANUALplus is familiar with standard figures
(full circle, polygon, slot, etc.). You can define these figures with a few
parameters. Complex contours are described with lines and circular
arcs.
You can arrange standard figures in linear or circular patterns.