HEIDENHAIN ND 2100G Installation - Manual (Page 15)

ND 2100G GAGE-CHEK Installation Instructions
en
17
4 Installation
NOTICE
Disturbances caused by lack of grounding or improper
grounding!
Never operate the product without proper ground
connection.
Connect the ground connector on the rear panel to
the central grounding point of the product.
Minimum cross section of the conductor: 6 mm
2 .
NOTICE
Risk of damage to internal components!
Do not engage or disengage any connecting elements
while the product is under power.
Depending on the product's equipment, the
installation may differ from the procedure
described in this chapter. If the Addendum
included with the product contains information
on the installation, the information given in
the Addendum takes precedence over the
information in this chapter.
The safety of any system incorporating the
use of this product is the responsibility of the
assembler or installer of the system.
The illustrations of pin layouts always show the
pin assignments of the connectors, and not of
the connections on the product.
Personnel requirement
The following steps are only to be performed by
qualified personnel!
For more information, see "Personnel
qualification", page 14.
4.1 Product overview
Rear panel
See A on the front fold-out page.
1 Power switch
2 Relay outputs
3 I/O interface
4 RS-232-C/V.24 port
5 Inputs for measuring devices
6 Power connector
7 Line fuse
The number and type of measuring device
connectors may vary from unit to unit.
Left side panel
The left side panel (as seen from the front) provides the
following connectors:
See B on the front fold-out page.
1 Speaker/headphone jack
2 USB Type A connector
3 RJ-45 jack for foot switch or remote keypad
4.2 Connecting power
WARNING
Risk of electric shock!
Improper grounding of electrical devices involves a risk of
serious injury or death by electric shock.
Always use 3-wire power cables.
Make sure the ground wire is correctly connected to
the ground of the building's electrical installations.
WARNING
Fire hazard from the use of power cables that do not
meet the minimum requirements!
Use only power cables that fulfill or exceed the
specified minimum requirements.
NOTICE
Surge suppressors limit the amplitude of potentially
damaging power line transients caused by electrical
machinery or lightning, and protect the product from
most power line transients that can corrupt system
memory or damage circuits.
Always connect the unit to power through a high-
quality surge suppressor.
Use the supplied power cable to connect the power
connector to a 3-wire grounded power outlet. For
information about the location of the power connector
on the rear panel, see "Rear panel", page 17.