HEIDENHAIN ND 231 B v.1 - Manual (Page 27)

27
Enter the associated compensation value,
e.g. 0.01 mm. Press MOD twice to
select COMP. NR. 02. (You cannot enter
any values in the POS. NR. 02 box).
Enter all further compensation points.
If you want so select a compensation
point directly, press CL and
simultaneously enter the desired
compensation point number.
Enter the spacing of the compensation
points on the axis to be corrected, for
example 2
10 µ
m (equals 1.024 mm).
Press MOD four times to select COMP.
NR. 01. (You cannot enter values in the
POS. NR. 00, COMP. NR. 00 and POS.
NR. 01 boxes.)
Nonlinear Axis Error Compensation
Selecting the compensation table, entering an axis correction
DATUM X1 or X2 (shown for approx. two seconds)
Enter the active datum for the error on
the axis to be compensated, e.g. 27 mm.
Press MOD to select the next input box.
SPACING
COMP. NR. 01
COMP. NR. 02
Conclude entry.
Select the operating parameters.
P00 CODE
Enter the code number 10 52 96,
confirm with ENT.
Select P00 CODE.
Together
with
MOD
MOD
4 x MOD
2 x MOD
2 x MOD
AXIS X1
Select the axis whose error is to be
compensated (X1 or X2). Press MOD to
go to the next input box.
MOD
X1 FCT. X1 or X1 FCT X2
Select the error-causing axis (X1 or X2).
Press MOD to select the datum.
MOD