HEIDENHAIN ND 231 B v.1 - Manual (Page 20)

20
Parameter Settings / Function Parameter Settings / Function
P43.1 REF Reference marks X1
One reference mark
SINGLE REF.
Distance-coded with 500 • SP
(SP: signal period)
500 SP
Distance-coded with 1000 • SP
(e.g. for HEIDENHAIN LS ...C)
1000 SP
Distance-coded with 2000 • SP 2000 SP
Distance-coded with 5000 • SP 5000 SP
P43.2 REF Reference marks X2
One reference mark
SINGLE REF.
Distance-coded with 500 • SP
(SP: signal period)
500 SP
Distance-coded with 1000 • SP
(e.g. for HEIDENHAIN LS ...C)
1000 SP
Distance-coded with 2000 • SP 2000 SP
Distance-coded with 5000 • SP 5000 SP
P44.1 REF Reference mark evaluation
Evaluate the reference mark
REF. X1 ON
Do not evaluate the reference
mark
REF. X2 OFF
List of Operating Parameters
P44.2 REF Reference mark evaluation 1)
Evaluate the reference mark REF. X2 ON
Do not evaluate the reference
mark
REF. X2 OFF
P45.1 ALARM Encoder monitoring X1
No monitoring
ALARM OFF
Monitor the frequency FREQUENCY
Monitor contamination CONTAMINAT.
Contamination + frequency FRQ. + CONT.
P45.2 ALARM Encoder monitoring X2
No monitoring
ALARM OFF
Monitor the frequency FREQUENCY
Monitor contamination CONTAMINAT.
Contamination + frequency FRQ. + CONT.
P50 RS232 Baud rate
110 / 150 / 300 / 600 / 1200 /
2400 / 4800 / 9600 / 19 200 /
38 400 baud
P51 RS232 Additional blank lines
during data output
BK LINE 1
0
≤
P51
≤
99
Default setting: 1
1) If an encoder input is unoccupied, it must be deactivated.
The settings go into effect after switch-on.