Polaris 2011 RZR - Manual (Page 112)

108
MAINTENANCE
Lights
Headlight High Beam Adjustment
1. Place the vehicle on a level surface with the headlight approxi-
mately 25 ft. (7.6 m) from a wall. Place the transmission in PARK.
2. Measure the distance from the floor to the center of the headlight
and make a mark on the wall at the same height.
3. Apply the brakes. Start the engine. Turn the headlights to high
beam.
4. Observe the headlight aim. The most intense part of the headlight
beam should be aimed 8" (20 cm) below the mark placed on the
wall in step 2. Include the weight of a rider on the seat while per-
forming this step.
5. If adjustment is necessary, turn the headlight adjustment screw to
adjust the beam.
6. Repeat steps 4-5 until the beam is properly adjusted.
25 ft.
(7.6 m)
8" (20 cm)
X X