Maintenance, Throttle system – Polaris 2011 RZR User Manual
Page 102
98
MAINTENANCE
Throttle System
Throttle Body/Idle RPM
Idle RPM is preset by the manufacturer. If the engine idle speed is not
satisfactory, please see your POLARIS dealer for adjustment.
Throttle Freeplay Adjustment
1. Remove both seats. Remove the
rear service panel. See page 31.
2. Locate the throttle cable adjuster
at the throttle body.
3. Slide the cable adjuster boot off
the cable adjuster.
4. Using a 10 mm open-end wrench,
loosen the adjustment jam nut.
5. Using an 8 mm open-end wrench,
move the cable adjuster until 1/16"
to 1/8" (1.5-3 mm) of freeplay is
achieved at the throttle pedal. See page 97. While adjusting, lightly
flip the throttle pedal up and down.
6. Tighten the jam nut.
7. Apply a small amount of grease to the inside of the boot and slide it
over the cable adjuster to its original position.
Boot
Adjuster
Jam Nut
- 2011 RZR S 2011 RZR 4 2009 Ranger RZR S 2010 RZR 2010 RZR EPS 2009 Ranger RZR 170 2012 ATV RZR 170 2016 ATV RZR 170 2013 RZR 170 2010 RZR 170 2011 RZR 170 2014 RZR 170 2010 RZR 4 2015 RZR 170 2012 RZR 2012 RZR S 2012 RZR 4 2013 RZR 2013 RZR S 2013 RZR 4 2011 Ranger RZR XP 900 2012 RZR XP 900 2013 RZR XP 900 2013 RZR XP 4 900 2012 RZR 570 2013 RZR 570 2016 RZR 570 2016 RZR 570 EPS