Polaris 2016 600 Rush PRO-S - Manual (Page 84)

82
PRE-RIDE INSPECTIONS
Start the Engine and Check
Before starting the engine, always refer to all safety warnings pertaining
to snowmobile operation. Never engage the starter when the engine is
running. Never start the engine without checking all vehicle components
to be sure of proper operation. See Before Starting the Engine beginning
on page 78.
Auxiliary Engine Stop Switch
Check the auxiliary shut-off switch for proper operation. Push the
switch down to stop the engine. Pull it up to allow restarting.
Ignition Key Switch
Make sure the engine stops when the ignition key switch is turned to
OFF.
Tether Switch (if equipped)
If your snowmobile has a tether switch, remove the tether from the
switch to make sure the engine stops immediately.
Lighting
Check the headlight (high and low beam) and taillight. Squeeze the
brake lever to verify the brake light illuminates. Make sure all lights
work properly before operating. See Power Management on page 32.
NOTE: If the brake light does not illuminate when the brake lever is pulled,
check the fuse. If the fuse is blown, inspect the brake lever switch wire
to verify it is not damaged. Replace the fuse. See page 124.
Mirrors (if equipped)
Adjust the mirrors so they can be used to their full advantage.
Operating Area
Before driving away, check your surroundings. Be aware of obstacles
and make sure bystanders are a safe distance from the snowmobile.