Polaris 2016 600 Rush PRO-S - Manual (Page 73)

71
THE PERFECT FIT
Left Hand Control Adjustment
IMPORTANT: Moving the left hand control without loosening the four
mounting screws will cause the housing locating pins to cut grooves into
the handlebar. When this occurs, the left hand control may not clamp
tightly to the handlebar. If the left hand control was inadvertently moved
without loosening the screws and is loose, loosen the mounting screws
and move the control block slightly to the left or right to relocate the
pins. Torque the screws to specification. See page 70.
1. Loosen the brake master
cylinder (A) mounting screws
and move it away from the
left hand control (B).
CAUTION! Use care when moving
brake master cylinder. Do not
damage the brake light signal wire.
2. Loosen the four left hand
control mounting screws.
3. Move the control block to the
desired position.
4. Tighten the control block screws to specification in the sequence
shown in the image. Do not over-torque.
Torque: 20 in-lbs (2.3 Nm)
5. Return the master cylinder to its specified position. Make sure the
clamp will not pinch the brake light signal wire. Tighten the clamp
screws to specification beginning with the front screw first, then the
screw next to reservoir. Do not over-torque.
Torque: 70 in-lbs (7.9 Nm)