Polaris 2016 600 Rush PRO-S - Manual (Page 66)

64
THE PERFECT FIT
Suspension Quick Setup Guide
Rear Track Shock Air Pressure
(SWITCHBACK ADVENTURE)
The factory-installed air assist
rear shock contains zero air
pressure, which will provide an
optimum ride when combined
rider and cargo weight is less
than 200 lbs. (90.7 kg). If rider
and cargo weight exceeds 200
lbs. (90.7 kg), use the following
procedure to increase shock air
pressure to the setting
recommended for your
combined rider and cargo
weight. Refer to the chart on the
following page.
NOTE: The shock air pump is
located in the protective
bag under the cargo rack.
1. Remove the air valve cap
from the shock.
2. Thread the pump’s valve
chuck onto the shock’s air
valve until pressure registers
on the gauge (approximately
6 turns).
NOTICE: Do not over-tighten as this will damage the chuck seal.
3. Stroke the pump a few cycles. Pressure should increase slowly. If
pressure increases rapidly, make sure the pump is properly fitted
and tightened onto the air valve.
NOTE: If the shock has no air pressure, the gauge will not register pressure.
Air Pump Bag
Cargo Rack
Bleed Valve Button
Air Valve Pump Valve Chuck
Air Pump with Gauge