Grass Valley DCR 4000 - Manual (Page 19)

v4.0
DCR 4000 User’s Guide | Using Venom with Viper 2-1
Chapter 2
Using Venom with Viper
2.1 Initial Screen Displays
When power is first connected, the following screen will appear for approximately 3 seconds.
This screen gives information about the status of the installed firmware, also the
Manufacturer's Serial number of the FlashPak is shown as FlashPak Nr xxxxx and the
Bluetooth identification name for the FlashPak as FPxxxxx
After the internal initialisation has taken place and the FlashPak is ready for use, the LCD
screen will show one of the following displays depending on whether or not there is a source
signal.
☞
Note
When operating with temperatures below 0°C (32°F) allow the system 10 minutes warming up
time before it becomes fully operational.
RECORD RECORD
POWER POWER
LIGHT LIGHT
ESC ESC UP UP
DOWN DOWN
PLAY PLAY
READY READY
SEL SEL
PLAY PLAY STOP STOP REC REC
FLASHPAK Nr. xxxxx
SC firmware: 3.0
BT NAME: FPxxxxxx