Grass Valley PDR 100 9GB Media Drive Upgrade - Manual (Page 32)

9GB Disk Drive Upgrade
22 PDR 100 9GB Disk Drive Upgrade
4. If the small LED cable inside the front panel does not have an EMI suppression
bead, remove the cable and install the supplied small LED cable which does
have an EMI suppression bead (
➊
in Figure 16).
5. If the LED cable does not have an EMI suppression bead, disconnect the other
end of the LED cable from the LED circuit board mounted in the front panel
and connect the supplied LED cable which does have an EMI suppression bead
(
➊
in Figure 16). Discard the old cable.
Figure 16. Rerouting the LED cable
6. Run the LED cable out the bottom right side of the front panel through the same
opening used for the On/Standby cable (
➋
in Figure 16).
7. Being careful not to pinch any cables, position the backing plate on the front
panel and install the six screws to secure the backing plate to the front panel (
➌
in Figure 16). Tighten the screws.
9686-26
If your cables don't have these
suppression beads, replace
the cables with provided
replacement cables.
3
1
2