Grass Valley PDR 100 9GB Media Drive Upgrade - Manual (Page 16)

9GB Disk Drive Upgrade
6 PDR 100 9GB Disk Drive Upgrade
Removing the Bottom Drive Tray Screws
You must remove the bottom drive tray screws to remove the old drive tray
from the PDR100 chassis. You’ll find it easier to remove the screws before you
remove the top covers.
Follow this procedure to remove the bottom drive tray screws.
1. Carefully tip the PDR100 up on its side to expose the bottom of the chassis.
2. Using a Torx tool with the T10 tip, remove the four drive tray screws from the
bottom of the chassis as shown in Figure 2.
Figure 2. Removing the bottom drive tray screws
9686-1