Grass Valley PDR 100 9GB Media Drive Upgrade - Manual (Page 14)

9GB Disk Drive Upgrade
4 PDR 100 9GB Disk Drive Upgrade
Installation Procedures
The procedures that follow take you step-by-step through the installation of the
9-GB Disk Drive Upgrade into the PDR100. The tasks involved in the physical
installation of this upgrade are:
• Disassembling the PDR100 to remove the old 4.5GB disk drives
• Installing the new 9GB disk drives
• Re-assembling the PDR100
When you complete the physical installation, proceed to the Verification
Procedure to complete the installation.
NOTE: Do not discard any items unless specifically instructed to do
so.
Before You Begin
Tektronix recommends that you remove the PDR100 from the rack and place
on a suitable work surface such as a table or workbench. The instructions that
follow assume that the PDR100 is resting on a flat, level surface.
WARNING: The PDR100 is too heavy for one person to remove from an
equipment rack. To avoid possible injury, get help when removing the
PDR100 from the rack.
1. Shut down the PDR100 and unplug the power cord and disconnect all cables
from the rear panel.
2. Loosen the front panel retaining screw and pull the chassis out until the slide
stop latches engage.
3. Press the stop latch buttons (visible in the stop latch holes) and with a helper,
carefully slide the chassis free of the rack and place on a suitable work surface.
!!