Grass Valley NetConfig Network Configuration Application v.2.0.12 - Manual (Page 31)

NetConfig — Instruction Manual 31
Using NetConfig
Setting IP Addresses
1. Use the Device IP Addresses command on the Configure menu pulldown, or
the corresponding Set IP button in the toolbar to view or change IP
addresses for any NetConfig compliant devices on your network. The
Change IP Addresses window (
Figure 28 ) will open.
Figure 28. Change IP Addresses Window
• Scrolling the inner window to the right reveals additional informa-
tion (Server 1 and 2, if applicable) and an Online field (
Figure 29 ).
Figure 29. Change IP Addresses Window, Scrolled Right
2. If you wish, you can use the Select Device Type pulldown in this window
to specify the kind of devices you want NetConfig to look for.