Grass Valley KAM-DEC-2AES v.4.0.3 - Manual (Page 63)

KAM-DEC-2AES Instruction Manual 63
Specifications
Line tilt < 0.5%
Field tilt < 0.5%
Differential phase < 1 degree
Differential gain < 1%
Signal/noise ratio (CCIR410
or EIA RS-250B) > 60 dB to 5.5 MHz
Phasing None
Picture centering error 0.0 ±20 ns non-adjustable
Decoding modes Three-line adaptive with two pre-programmed adaption threshold levels high/low
Blanking start/end SMPTE170M or CCIR624, non-adjustable
Composite In Control
Overall video gain range 44% to 219% in 0.5% steps, 100% default
Black range -21.5% to +22% of luma full-scale in 0.1% steps, 0 default
Hue range -180 to + 179 degrees in 0.1 degree steps, 0 degree default (525 only)
Setup processing in vertical Line by line on/off (525 only)
Vertical blanking processing Line by line blank/notch decode/pass
Table 8. Frame Sync/Timing Specifications
Parameter Value
Video Frame Sync Timing Control Parameters
Delay adjustment (main) 0 to 1 frame in 37 ns steps
Additional delay, SDI out 0 to 151 µs in 37 ns steps
Table 9. Main Video Processing Specifications
Parameter Value
Main Video Frame Processing Control Parameters
Y gain ± 50% in 0.4% steps, 100% default
Y offset ± 3.5% of 100% white in 0.11% steps, 0% default
B-Y gain ± 50% in 0.4% steps, 100% default
B-Y offset ± 3.5% of 100% white in 0.11% steps, 0% default
R-Y gain ± 50% in 0.4% steps, 100% default
R-Y offset ± 3.5% of 100% white in 0.11% steps, 0% default
Color bars on/off
Table 7. Composite Input Specifications
Parameter Value