Grass Valley KAM-DEC-2AES v.4.0.3 - Manual (Page 62)

62 KAM-DEC-2AES Instruction Manual
Specifications
Specifications
Note Specifications are subject to change without notice.
Table 6. SDI Output Specifications
Parameter Value
SDI Output
Number of outputs 1
Signal type Serial digital video conforming to SMPTE259M 10-bit 4:2:2 component
digital signal
Signal level 800 mV ±10%
Output impedance 75 Ω
Connector type 75 Ω BNC on rear module
DC offset < 0.5 V when terminated into 75 Ω
Output return loss >15 dB up to 270 MHz
Jitter Conforms to SMPTE17.12/002 <400 ps above 1 KHz
Rise/fall time 700 – 900 ps (20 – 80% amplitude)
SDI I/O Control Parameters
Vertical blanking processing Line by line blank
Table 7. Composite Input Specifications
Parameter Value
Composite Input
Signal types Composite analog video conforming to:
NTSC (525/59.9) SMPTE170M
PAL-B/PAL-I (625/50) CCIR 624-4
PAL-M (525/59.9) CCIR 624-4 (note, PAL-M input not supported by 2000GEN)
Level 0.5 V p-p to 2 V p-p, 1 V p-p nominal
Impedance 75 Ω terminating
Signal source 75 Ω BNC on rear module or internal signal
Return loss > 40 dB to 5.75 MHz
Common mode rejection ratio > 60 dB to 60 Hz
HUM peak < 4.5 V p-p
Composite In Performance
Sampling 27 MHz (2x oversampling)
Input quantization 12 bits
Overall processing accuracy 10 bits
Luma frequency response ± 0.1 dB to 5.5 MHz
Chroma (R-Y,B-Y) response -1.5 dB @ 1.3 MHz
Group delay error < 5 ns to 5.5 MHz
Chroma/luma delay < 10 ns
Luma non-linearity < 0.15%
K factor (2T) < 0.5%