Grass Valley Kaleido Remote Control Protocol Gateway May.2011 - Manual (Page 27)

USER’S GUIDE
Kaleido Remote Control Protocol (Gateway) | 23
Returned value will have the form:
 mode="XXXXX"
Where XXXXX is the mode, which can be any of NORMAL, MUTE or
–20 dB.
 : The command was not executed, due to a spelling error or invalid parameter. In
this case the audio monitoring mode remains unchanged.
setKAudioOutMode KX K2 AQ
Note: This command is currently not supported on the KMV-3901/3911 models.
To set the Audio Monitoring Mode the following command is used:
set mode="XXXXX"
Where XXXXX is the value at which the mode must be set. Valid values are NORMAL, MUTE
and
–20 dB.
Returned value will be any of:
 : The command was correctly interpreted. The Audio Monitoring Mode was set to
the specified value.
 : The command was not executed, due to bad spelling or invalid parameter. The
Audio Monitoring Mode remains unchanged.
setKVerticalOffset AQ
This command is used to position the CPU’s graphic output vertically within the final DVI output
on the display. The Kaleido-
Alto/Quad’s CPU includes up to 1024 lines, whereas the final output
includes up to 1200 lines.
set offset="NN"
Where NN is the number of line s (between 0 and 175) by which to offset the CPU’s graphic
output, from the top of the final DVI output.
Gateway response:
 : The command was recognized by the Gateway.
 : The Gateway was not able to recognize the command.
setKIcontrolMode AQ
This command is used to enable the Kaleido-Alto/Quad to key the detected mouse pointer colors
on video.