Grass Valley Kaleido Remote Control Protocol Gateway May.2011 - Manual (Page 23)

USER’S GUIDE
Kaleido Remote Control Protocol (Gateway) | 19
Gateway response:
 : The command was recognized by the Gateway.
 : The Gateway was not able to recognize the command.
setKDisableAlarmGroup KX K2
This command is used to disable the specified alarm group or virtual alarm.
set
name="NameOfTheGroupToDisable"
Where NameOfTheGroupToDisable is the name of the alarm group (for a Kaleido-K2 multi-
viewer), or virtual alarm (for a Kaleido-X Series multi-viewer model) you wish to disable.
Note: In the case of a Kaleido-X Series multi-viewer model, this parameter can be the
path/friendlyName of the virtual alarm or its URI. The virtual alarm will be set to OFFLINE.
Gateway response:
 : The command was recognized by the Gateway.
 : The Gateway was not able to recognize the command.
setKSaveLayout K2 AQ
This command allows the user to save the currently displayed layout to a file.
set name="FileName"
Where FileName is the name of the file that will contain the layout.
Note:
Do not specify an extension to the file name. The file extension ―.kg2‖ (for Kaleido-K2
layouts) or ―.xml‖ (for Kaleido-Alto/Quad/Quad-Dual layouts) will be automatically added by the
system.
Gateway response:
 : The command was correctly interpreted and executed.
 : The command was not executed, due to wrong spelling or invalid parameter.
getKAudioOut KX K2 AQ
This command allows the user to get the selected audio monitoring output.