Grass Valley Kaleido Remote Control Protocol Gateway May.2011 - Manual (Page 25)

USER’S GUIDE
Kaleido Remote Control Protocol (Gateway) | 21
Notes:

A session with user privileges must first be opened for this command to work on a
Kaleido-X or Kaleido-X16 multi-viewer.

This command is currently not supported on the KMV-3901/3911 models.

Streaming sources are not supported on the Kaleido-Alto/Quad/Quad-Dual.
DETAILS
Where DETAILS will differ depending on the type of audio source being selected for monitoring,
as shown below.
To select a streaming source, format the command as follows:
set Type="STREAMING" IP="999.999.999.999"
FeedID="XX"
Where:
o 999.999.999.999 is the IP of the machine from where the stream occurs.
o XX is the identifier of the feed to use.
To select an audio card source, format the command as follows:
set Type="AUDIOCARD" Input="999"
Where 999 indicates the input from the card.
To select an embedded source, format the command as follows:
set Type="EMBEDDED" Input="AAA" Group="BB"
AES="X"
Where:
o AAA indicates the video input.
o BB indicates the group. Valid values range from 1 to 4.
o X indicates the AES. Valid value can be either 1 or 2.
To stop audio monitoring and mute the audio output:
set Type="NONE"
Gateway response:
 : The command was correctly interpreted.
 : The command was not executed, due to wrong spelling or an invalid parameter.
Note: You may select any audio source for monitoring, independent of whether it is being
metered in the current layout, with the exception that a streaming source must be part of the
current layout.

If the source is included in the layout, the meter assigned to it will be highlighted.