Grass Valley Kaleido Remote Control Protocol Gateway May.2011 - Manual (Page 16)

USER’S GUIDE
12 | Kaleido Remote Control Protocol (Gateway)
getKRoomList KX
This command is used to obtain the list of rooms known to your multi-viewer system.
Gateway response:
 Room ARoom B
 : The Gateway was not able to recognize the command.
setKStatusMessage KX K2 AQ
This command associates an Alarm state with an ID. The Kaleido can be configured to listen to
alarm status messages from the Gateway, and thus report the state it receives. This is a
convenient way of reporting Alarms to the Kaleido.
set id="ID" status="Status"
message="Message"
Where:
o ID is the identifier that will receive the new state.
Note: Kaleido-Alto/Quad/Quad-Dual will only accept numeric values for this parameter,
in the range 0 to 1024. The Kaleido-K2 and Kaleido-X series do not have this limitation.
o Status is any of the available statuses:
Status Alternate (legacy)
status Kaleido-X Series Kaleido-K2/Alto/Quad/Quad-Dual
DISABLE DISABLE Disabled Disabled
NORMAL OK Normal OK
MINOR WARNING Minor Warning
MAJOR MAJOR Major (not supported)
CRITICAL ERROR Critical Error
o TheMessage is reserved for future use, and is ignored.
Gateway response:
 : The command was recognized by the Gateway.
 : The Gateway was not able to recognize the command.