Grass Valley Kaleido Remote Control Protocol Gateway May.2011 - Manual (Page 12)

USER’S GUIDE
8 | Kaleido Remote Control Protocol (Gateway)
 : The Gateway was not able to recognize the command.
Note: This command closes the current connection to the client via port 13000. This connection
must be re-established before another session can be opened. If you are using HyperTerminal, it
will automatically re-establish the previous connection if you begin typing new commands, but
other clients may require you to manually reconnect.
getParameterInfo KX
This command serves two purposes: it can retrieve the current system’s name, or the version of
the Kaleido-X Software installed on this system.
To obtain the software version, the command is:
get key="softwareVersion"
Gateway response:
 softwareVersion="Software Version"
 : The Gateway was not able to recognize the command.
Example:
softwareVersion="4.XX-build.102"
To obtain the system name, the command is:
get key=”systemName”
Gateway response:
 systemName="System Name"
 : The Gateway was not able to recognize the command.
Example:
systemName="Cougar-X"
getKCurrentLayout KX K2 AQ
This command retrieves the name of the current layout.
Gateway response:
For a Kaleido-Alto/Quad/Quad-Dual multi-viewer:
 Currentlayout.xml
For a Kaleido-K2 or a Kaleido-X series multi-viewer: