Grass Valley Kaleido Remote Control Protocol Gateway May.2011 - Manual (Page 26)

USER’S GUIDE
22 | Kaleido Remote Control Protocol (Gateway)

If the source is not included in the layout, the sound will be routed to the audio monitors, but
there will be no indication of the source, in the layout.
getKAudioOutVolume KX K2 AQ
Note: This command is currently not supported on the KMV-3901/3911 models.
This command retrieves the audio monitoring volume currently used.
The returned value will have the form:
 volume="XX"
Where XX is the value, expressed in dB, at which the audio monitoring volume is set. This
value ranges between -96 dB and +24 dB for a Kaleido-X series multi-viewer, and
between -90 dB and 0 dB for a Kaleido-K2/Alto/Quad/Quad-Dual. Fractions of dB are
supported on the Kaleido-X series multi-viewers only.
 : The command was not recognized.
setKAudioOutVolume KX K2 AQ
Note: This command is currently not supported on the KMV-3901/3911 models.
This command sets the audio monitoring volume.
set volume="XX"
Where XX is the value expressed in dB at which the volume will be set. Valid values range
between -96 dB and +24 dB for a Kaleido-X series multi-viewer, and between -90 dB and 0 dB for
a Kaleido-K2/Alto/Quad/Quad-Dual. Fractions of dB are supported on the Kaleido-X series multi-
viewers only.
Note: If the audio signal is muted, executing this command will unmute the signal.
Returned value will be one of:
 : The command was correctly interpreted. The volume was set to the new value.
 : The command was not executed, due to a spelling error or invalid parameter.
The volume remains unchanged.
getKAudioOutMode KX K2 AQ
Note: This command is currently not supported on the KMV-3901/3911 models.
This command retrieves the audio monitoring mode currently used.