Grass Valley Kaleido Remote Control Protocol Gateway May.2011 - Manual (Page 20)

USER’S GUIDE
16 | Kaleido Remote Control Protocol (Gateway)
programID
timeOfDay
timeZone
o The value field is escaped as defined in the XML protocol for an attribute value.
o For instance, ABC"DEF\GHIMNO/PQR&STU;VWX'YZ
becomes ABC"DEF\GHI<JKL>MNO/PQR&STU;VWX'YZ
o The attributes order is not guaranteed and may change for two consecutives calls to the
same command.
 : there is a syntax error in the XML command.
Note: If the MultiData component is not assigned to a text component, no values will be included
in the information returned to the user from the gateway. Make sure to assign the MultiData
component to a text label component.
setKTimer KX K2 AQ
This command is used to configure the specified countdown timer component.
set id="TimerID" preset="
HH : MM : SS
" direction="Direction"
loop="Loop"
Where:
o TimerID is the ID of the countdown timer component to modify.
o
HH : MM : SS is the preset value for the countdown timer component.
o Direction is the direction to count, either
UP or DOWN .
o Loop indicates if the counter must count continuously. This value can be either
ON or
OFF .
Gateway response:
 : The command was recognized by the Gateway.
 : The Gateway was not able to recognize the command.
setKTimer2 KX K2
This command is used to configure a timer in a Kaleido-K2 or Kaleido-X series multi-viewer
system.
set TimerName="NAME" StartTime="HH:MM:SS:FF"
PresetTime="HH:MM:SS:FF" TimerMode="Timer mode" EndMode="End mode"
Where: