Grass Valley K2 Dyno Installation v.2.0 - Manual (Page 22)

About K2 Dyno Replay Controller modes
The K2 Dyno Reply Controller operates in the following modes:
• Dyno mode – The Dyno application is open for normal operations such as capturing and replaying
highlight clips.
• Maintenance mode – The Dyno application is closed and the Windows operating system desktop
is available for system tasks such as network configuration and software update.
By default, the K2 Dyno Replay Controller is in the Dyno mode. You must manually put the unit
in the maintenance mode, which requires a restart.
Start K2 Summit/Solo
1. Start up the K2 system.
2. Log on to the K2 system with the default Windows administrator account:
• Username: Administrator
• Password: adminK2
(The password is case sensitive)
At first startup, End User License Agreements appear on the screen. Accept the agreements to
continue.
The Power LED goes on and stays on. The Service LED stays off. Startup processes complete
in approximately two minutes and the K2 system is ready for connection and operation.
Disable write filter
1. If you have not already done so, log on to the K2 system with Windows administrator privileges.
2. From the Windows desktop, click Start | All Programs | Grass Valley | Write Filter Utility .
FBWF Manager opens.
3. Under Filter Settings, set Filter to Disable .
Do not modify other settings.
4. Click OK .
5. When prompted, restart the K2 system.
Proceed as follows:
• If a K2 client on a K2 SAN, skip ahead to software installation tasks. Network configuration is
already done on a K2 client operating on a K2 SAN.
• If a stand-alone K2 client on which the network is not yet configured, continue with the next
task.
22 K2 Dyno Controller Installation Manual 14June 2011
Configuring networks