Grass Valley K2 Dyno Installation v.2.0 - Manual (Page 12)

K2 Summit/Solo with Dyno installation checklist
Comment Task
Refer to K2 Summit/Solo system requirements
on page 14.
Verify system requirements
Procure or verify supporting systems and
software. Refer to
Procure software and/or
hardware on page 14.
Procure software and/or hardware
Refer to K2 Dyno Replay System Quick Start
Guide. Both the K2 Dyno Replay Controller
and the K2 Summit Production Client come
with their own specific USB Recovery Flash
Drive. Make sure you keep each Recovery
Flash Drive with its own specific unit. Do
not lose the Recovery Flash Drive. Unpack devices
Refer to QuickStart Guides for your K2
products. Cable devices
Disable the write filter. Refer to Configure
network on stand-alone K2 Summit/Solo on
page 23.
Configure network on K2 Summit/Solo
At the MS-DOS command prompt, use the
ping command.
Verify network communication
Dyno license is required. AppCenter Pro
license is also required. On K2 Solo Media
Server, the AppCenter Pro license is standard.
On K2 Summit Production Client, the
licenses must be installed, if not already
present. Refer to release notes for
compatibility information and upgrade
instructions regarding K2 System Software
and licensing. Upgrade and/or license software, if necessary,
on K2 Summit/Solo
Refer to release notes for compatibility
information and upgrade instructions. Upgrade software, if necessary, on K2 Dyno
Replay Controller
Refer to Configure K2 Summit/Solo channels
on page 26.
Configure K2 Summit/Solo channels
Refer to Start a new session on the K2 Dyno
Controller on page 27.
Configure K2 Dyno Replay Controller for
connection to K2 Summit/Solo
Next: Refer to K2 Dyno Controller User Manual and K2 Dyno Replay System Quick Start
Guide for operation instructions.
12 K2 Dyno Controller Installation Manual 14June 2011
Overview of systems